This how to, will tell you how to setup your new board from the shop.
1) Take your board out of the plastic if wrapped and lay it on a flat surface. If its on the wood floor, put a towel down so if your board moves it will not get scratched.
2) Take you’re binding out of the box lay them vertically upward so you can screw them into the hole on the board. Depending on how wide your stance is you, can adjust it with the 8 holes on the board. If you ride regular you want your left foot in front and if you ride goofy like me you put your right foot in front. You can also change the angle of the binding by loosening the screws, holding the binding down and twisting the binding itself making sure that the plate in the middle doesn't move.
3) Next take your Screw driver and tighten all the bolts. Make sure everything works and the binding opens and closes.
4) I also recommend putting a stomp pad and leash on your board. If you don't know what a stomp pad is, its a gel like pad that you put near your rear foot so when you get off a lift you have a place to put your foot so your foot does not slip and you have traction. A leash is a lanyard like rope that clips onto your board and boot. When your on the lift and your binding fails and your board is lose it is hooked onto the boot of your foot. A good website for these to things are Princetonski.com
5) If you want you can wax your board, it is not nessacary if the board is brand new. I use this wax called Swix I got it from Princeton ski store and it works great. With the wax you rub it on and around to take the excess wax off the Snowboard.
6) You can also put decals on your board. If you want to do that you have to clean the surface you’re putting the decals on with soap and water and make sure you dry it off good. Carefully place it where you want it and make sure you get all the air pockets out.
You can find a lot of the items you need on Princetionski.com